|
Texas Refinery Corp. has always
had good products for hydraulic systems, but continuous
research and development has improved things once again.
New generation base stocks and powerful additive systems
in huge amounts make Texas Refinery Corp.'s
HYDRAULIC OIL
a high performance giant. In
today's hydraulic systems, which operate under higher
pressure and heat loads, there's a real need for
superior hydraulic oils and the answer comes from Texas
Refinery Corp.'s HYDRAULIC
OIL. |
Reduces
Costly Wear
It's a
high quality, stable product formulated to provide excellent
performance. Increased protection against surface wear is
accomplished with the use of
HYDRAULIC OIL - - it forms a film
on metal surfaces, reducing metal to metal contact. Texas
Refinery Corp. incorporates more zinc (an anti-wear additive)
into its HYDRAULIC OIL,
than is required on most equipment specifications - - an extra
step to prolong the life of equipment. Reducing friction wear
often reduces operating temperatures and that in turn helps
increase the life of the oil and the equipment.
Resists
Chemical Breakdowns
Hydraulic oils are subjected to many problem-causing factors - -
high temperatures, water, air, and foreign debris. This
combination leads to oxidation, producing sludge, varnish,
acids, eventually a thick gummy material in the oil. To prevent
this, Texas Refinery Corp. manufactures
HYDRAULIC OIL
from new generation base oils which have a high stability and
then TRC boosts the stability even further with extra portions
of powerful anti-oxidation additives. In an oxidation test, it
performed satisfactorily for over 10,000 hours, in most grades -
- better than five times the target normally sought.
Protects
Seals
A
hydraulic piston operates under high pressure, requiring a
lubricant which reduces friction of the seal material, without
damage to the seal itself. It is Formulated with the most
up-to-date additives to protect seals. Friction is reduced and
longer service life is obtained. This savings is accomplished by
using superior quality oils and additives used in Texas Refinery
Corp.'s HYDRAULIC OIL
formulation.
Resists
Foaming
For
peak efficiency, hydraulic systems must use an uncontaminated
oil as an operating medium. Water contamination, among other
things, causes foaming, especially where elevated temperatures
are encountered. Also, air entrapped in the system, can cause a
foaming problem. Texas Refinery Corp.'s
HYDRAULIC OIL
contains special anti-foam chemistry in large amounts, so the
fluid releases any air or water that may be causing the foam.
Reducing foam also decreases heat, and improves the life of the
oil and the equipment.
Protects
Against Rust
If an
oil is formulated properly, metals should not rust, even if
moisture is present. HYDRAULIC OIL
has the special additives in large quantities to protect metal
surfaces from rust. The film forming chemistry, coats all metal
surfaces with a thin film, preventing moisture and other rust
promoters from reaching the surfaces. With the use of
HYDRAULIC OIL,
these worries of rust are over.
Dependable
An
inferior hydraulic oil becomes thick when cold and can cause a
pump to cavitate. When weather is hot, the oil becomes thin,
causing a loss around seals. The thin oil also tends to
accelerate wear and give other problems. This product shows very
little change in its flow characteristics through its service
life. The better quality base oils and superior additives in
large quantities helps HYDRAULIC
OIL maintain its viscosity and
performance - - for dependability! |
®